My Luxman Integrated has AC Inlet Envy


I love my Luxman 507ux, it does so many things right, so soon after I got it I built a shielded power cable as an upgrade to the relatively plain cable that came with it.

To make a long story short, after trying out a number of different cables and female IEC plugs it seems the AC inlet has prongs which seem too short. For sure, the Luxman has no ground pin. I'm sure that this means it's not required, so that’s not an issue. What is an issue is that even a Wattgate plug, which are famous for a tight grip, can’t stay in. Even a little wiggle can disconnect the amp.

It seems either or all of these are true:

  • The missing ground pin is keeping plugs from feeling very grippy
  • The pins are too short
  • The pins are too thin

If I play with a cheap power cord, it seems like the AC doesn’t connect unti lthe very last 2 mm of travel of the plug. This seems wrong.

I bought a cheap replacement inlet and it just feels so much better. Meaning, I can feel the plug grip the pins much earlier, and they all grip much better.

Anyone else have issues with Luxman inlets??

 

PS - I absolutely insist on building my own power cables. This is my hobby not yours so please stop trying to convince me my problem is that I didn’t buy your boutique brand.

 

erik_squires

@erik_squires Wrote:

As a matter of fact, what I ordered wasa not a C14 but a C16 inlet. The only difference I can tell is that the C16 inlet has a plastic ridge under the ground pin.

I agree, I think your Luxman originally has a C-17 C-18 two prong plug.

Mike

Great! @erik_squires 👍

Please let us know your progress. BTW, since you going to open the chassis of your Luxman, Would you do us a big favor to check the power transformer primary winding if there multi tap or not, so we can be sure the possibility of voltage conversion.

TIA

 

@imhififan I will IF I open the Lux.

I have a chance I can do everything through the outlet hole.

I'm afraid that in my years of reading on Accuphase vs. Luxman, the lack of a multitap primary on the transformer was always a given.  If I find out otherwise I"ll let you know.

I have a chance I can do everything through the outlet hole.

If possible, try turn the original C18 inlet 180° before you replace it, perhaps that can help the aftermarket plug stay in better since the two pins are on upper side.

Hopefully you don’t need to replace the inlet after all 😌

IME, install the IEC inlet 2 pins on upper side is better even if it is a C14 inlet.