Bi wiring v single run w jumpers

Not much to add to these three excellent answers. I would only question how Michael came up with two-thirds of an answer. ;^)

No one can tell you what will work best for you, just as no one can tell you what your favorite adult beverage is.
You simply have to try for yourself, and make your own decision.

Zd 542 I know which one runs what drivers My point was it is just another issue . In other words if the top just drives the tweeter I would be inclined to go to the bottom but if the top drives the mid and tweeter i would put my cables to the top as it wwould have more effect on what I hear. Under 250HZ is more feel then anything

3)Connecting the + conductor to the top terminal and the - conductor to the bottom terminal. Some users here have actually reported that to be preferable to the previous two sub-options.

This is one I see in pictures and am wondering what it really does??

This is one I see in pictures and am wondering what it really does??

If the connections are made to either the bottom two terminals or the top two terminals (as in sub-options 1 and 2), the current path between the amp and one section of the speaker would include two jumpers, while the current path between the amp and the other section of the speaker would include no jumpers.

If the connections are made to a diagonal pair of terminals (as in sub-options 3 and 4), the current path between the amp and each of the two sections of the speaker would include one jumper.

Assuming good contact integrity in all of those cases, and assuming that the length of the jumpers is minimal and that they are of decent quality, I can think of no reason why that difference between the two cases would result in sonics that are perceptibly different. But who knows?

Regards,
-- Al

OK let me ask this One run of AP Oval 9 with jumpers or bi wire (two runs) or Oval 12? I did try this on one set where I could not tie things together inside. The biwire seemed more open and slightly relaxed. Voices where more vertical With the single run of 9 I felt like I was looking at the floor where voices were coming from, so to speak. More airy

Biwiring can sound marginally better than single wire cables if a/ the speaker is properly separated in the crossover to take full advantage of biwire terminals and b/ the cables are true biwire cables (ie: physically separated into positive and negative runs either internally within a single outer shieling, or preferably a shotgun run of cable). If not, then investing in biwire cables is a waste of money.

Alternatively, if the speaker is not properly setup for biwiring, then using high end jumpers (preferably from the same manufacturer) with single wire cables should sound noticeably better than using the cheap jumper plates which come with most biwireable speakers.

I can't comment on other options suggested above as I have no experience with them.