PS audio m1200

Hi, I have no experience with the M1200's but I did have the M700's. I used these to drive my 4ohm Kef Reference 5's. Although these have a reasonably high sensitivity I do play them quite loud and the M700's coped admirably with plenty more to give. I was so impressed with them (and PS Audio) that I wanted to upgrade, the 1200's would of been a natural progression but I jumped straight to the BHK 300'S - no regrets there. I suspect that the 1200's will have oodles of power for your D3's. My advice is don't get too hung up on specs, they can sway you away from making good decisions.

cheers, Mark

I am not an audiophile, but have spent like one.

I have the ref 6 paired with a Bryston 4 b cubed.

I find if I want to crank it up the volume flattens out.

It was relayed to me that the design of the volume control on the ref pre is the limiting factor, something to do with gain.

Will a more powerful amp solve this? I don't think so.

On that note does anyone know if that vole control on the ref 6 can be modified?

Mossy

Thank you all for the info and advice. I will continue to research your recommendations. 

And mossyrocks, it looks like those amps have 2 options for gain. Does it make a difference between the 2 gain options? And also, I am no expert either, but I never looked much into Bryston because the input impedance is lower than what is recommended for the ARC ref 6. Could it be due to that?

Gain switch makes a difference, but the ceiling is still there.

Can't comment on input impedance. The pairing was suggested and confirmed by multiple dealers.

Interesting. I have the ref 6 and don't have that problem. Good luck and I hope you can figure it out