micro seiki dqx-1000
takes 3 arms, need pivoting tonearm mount(s), then pick your arms, 1, add one, add another, as your LP interest grows
another, says different seller
arm mount, pivots for arm length
Turntables: 2 Tonearms. What do you Have or Know About?
……………………………………………………………………………………………………..
Turntables: 2 Tonearms. What do you Have or Know About?
……………………………………………….
I think it would be interesting/fun to create a list of 2 Tonearm TT’s
(2 arms or potential for 2 arms or more)
Links to Virtual Systems; Links to ‘For Sale’; Links to Manufacturers Sites; Photos
......................................................
To Insert Photos, here’s how:
How to Insert Photos in Audiogon Posts
ALL CREDIT TO DOGBERRY
I’m an old man (74), U can do it.
Hopefully this makes sense
INSERT Photo in an Audiogon Post
………………………………………………………………………..
My 3 Arm Turntable: Became the Jewel of my System, 8th Photo Here
https://www.audiogon.com/systems/9511
…………………………………………
How did this happen? Covid Times, I upgraded eveything).
I listen to a lot of Jazz, both Stereo and Mono.
After learning here the advantages of a true mono cartridge, I wanted a second tonearm for a MONO cartridge ‘ready to go’. Got big plinth made for 2 arms, JVC VICTOR PL-2. Stereo cartridge on right, Mono cartridge rear.
Then I resurrected a MM Cartridge (new stylus from Jico). Squeezed an 'illegitimate' third tonearm on.
Right long arm is MC (fixed/difficult adjustments);
Rear Arm is MM (removable headshell/easy and quick adjustments of Tracking Force, Anti-Skate and VTA).
Left side arm MONO (fixed/difficult adjustments)
;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;
@elliottbnewcombjr I would like to say, I learnt my lesson with Granite Monoliths. That is a tale I can't tell, I have a 250Kg Granite Lintel/Engineers Plate, used as part of the support structure for the 845 Monoblocks. The equipment Racks are seated on Steel Plates of a dimension 900 x 700 x 15 (36" x 28" x 5/8") again a Holiday is needed following the experience of being put in place. I am hoping my 'new kid on the block' - 'go to' material, is a worthy substitute for these when I return to using the system. |
pindac OVERKILL: (websters): ’Found under the equipment rack’ My final TT support, to deal with my springy floors, drop the needle, "gimme 2 steps..." Notice, my TT’s oversized plinth is on a deeper glass top I had made, it cantilevers a few inches over the back of the normal depth ’glass topped’ racks below. Fortunately the Spinner’s weight is forward, so luckily no rear support under the back edge of the glass was needed. I designed and built the racks below it, 3 heights
They can surround equipment with some heat, they are ventilated, wide open in the back, see my tube preamp below my tube amp.
lower equipment pulls forward without disturbing upper unit
other photos here https://www.audiogon.com/systems/9703 anyway, hard not to digress, but to note, many TT’s that take multiple arms need more space, depth, or width, like my friend’s Luxman PD444 My OEM dust cover is lift off, Luxman's is hinged
|