OK, so now that I am looking at the connections I used for the 2 LEDs, I see on the manual that on page 7/42 6.2 P101: Basic Control Connector, there appears to be a jumper from pins 3 & 6. This allows the 1200AS to automatically turn between on mode and standby mode. I also had to connect the 3 signal sense inputs (pin 20,21, 22 of P102) to the audio input connector (XLR/RCA connector in chassis). So when music input appears, the 1200AS will automatically power on from standby and after no music/signal, it will go into standby after around 13 minutes. Perhaps I could cut the wires that are going to the LEDs to see if that works?
Help with Icepower 1200as2 amp please!
Hello everyone! I am having an issue with my Icepower 1200as2 module. I have ran this amp for a few years and all of a sudden it starts going into a standby mode, then comes back on for a little while, then back to standby even when a signal is passing through. When I first built this DIY project using the 1200as2 module, I hooked up 2 LEDS on the front of the chassis. When first powering up the amp, the amber LED would light up until a signal was picked up through the RCA interconnects circuitry? So if I wasn't playing anything through the amp, the amber LED would light up and stay on until a signal was detected. I really don't want to trash the module, so if I can get some help to perhaps fix this issue, I'd be very grateful and appreciative! Thanks for any help!
Best,
Jacques
- ...
- 19 posts total
- 19 posts total