Costliest Brainfart


Yep.

I had one today.

While reorganizing my audio rack, with my TT still pretty on top, I decided I just had to level it just right.  And to make this happen, I decided I just had to place a block of wood under the spikes.  And since the block was fairly thick I just had to keep lifting the front higher and higher.  And higher.  
 

The table slid right off the back and came crashing down onto the floor.  Moerch UP4 arm, bent.  Karat 17d3 stylus, cocked to the side.  The table itself might be salvageable, but I was so disgusted with myself I didn’t bother looking.

A 2K+ brain fart.

Who needs vinyl anyway!

Please list your mishaps if for no other reason than to make me feel a bit better.  😉

128x128audiodwebe

Not audio related but:

My in-laws are constantly fighting, during a rather heated session he has to drive her to an appointment.  And yes he mashes on the gas and takes out the (unopened) garage door completely as well as doing enough damage to his car so that it is undriveable. 

Car goes to dealer to get fixed.  Call comes in the car is ready for pickup. Mother-in-law drives him to dealership to get it.  He is now following her home and with no warning she crushes on the brakes and he rear ends her.  Both cars are really screwed up.

But wait there's more:  He gets out of the car and proceeds to curse her out loudly. Her story is she didn't want to hit a squirrel! He is now enraged and the volume goes up and vitriol gets worse.  Neighborhood people are all calling the cops telling them there is an assault going on. 

Cops arrive and are about to mace him and cuff him when his wife steps in and says he's my husband.  Cops are incredulous  and want to arrest him anyway but she talks them out of it.

And now they have no vehicles. Must have been a fun night back at the ranch.

Too funny for real life.

Regards,

barts 

 

My beloved KEF Ref 105.2s...

Two wall sockets next to each other, one always on, one switched so it can turn on/off the table lamp.

Plug the amps into the wrong outlet (switched). 

Turn off the lights. Oops, the music disappears. 

Double oops... turn the juice on right away. 

Pop. What is the sound of two woofer baskets bending? 

Woofs no longer made. Very rare... 

Thankfully just one of several systems so music is still in the air.  

Search, find and replace. Works perfectly. 

Now have several working spare woofs in inventory.. 

Oh, well... 

Yup, just stuff as George Carlin might say... 

Pulled an NYAL Minuet in A preamp out of storage where it was for over a decade and installed it in my system.  I remembered that it had some issue with one of its channels.  It was a Saturday morning and I turned it and the system and went to the kitchen to make coffee.  This preamp has a 45 second turn on delay for the circuit to settle in and it can output something like 30 volts(it could run a mile of interconnect cable).  I thought that I turned the balance control all the way to the right channel but in fact, turned the volume control all the way to the right (UP!) waiting for NPR radio to come on, and boy did it come on.  I nearly pi##ed myself moving as quick as I could to turn it down, but alas, it took out both mid/bass drivers in my speakers that have not been manufactured for a while.  It wasn't until later, after purchasing new speakers that I found out about  Bill LeGall and Millersound who was able to rewind the voicecoils and whatever else needed to be done.

   So if you do a "Stupid" as I did and need the impossible done, at least with speaker drivers, this(Millersound) is "The Place" to have them made right again.

 

I had just a day before received a pair of the new Stage Accompany Ribbon drivers

with very powerful Neodymium magnets. I opened the boxes and placed the new drivers on the floor. Face down so as to keep anything from getting into the ribbons. Plainars really.  So after cleaning up the packaging. I sat down to listen to some music. I live by myself and leaving the drivers on the floor was no issue.

After an hour or so, I looked down and said to myself " I had better put those new drivers somewhere more safe..heck I could damage them being on the floor myself". I pick up one of the drivers and place it on my work kitchen table..where I had a small project being done.  Small bolts siiting on the table. Not thinking I had a powerful magnet in my hand...just as I was about to take my hand off the driver...woooosh !!! In the blink of an eye  4-6 small bolts sucked up by the magnet go right through the ribbon...POOF !!!!  $450 gone, disappeared.  right..." I had better pick those driver up off the floor because I don't want to damage them... good job !!!!

More to discover