Any point in upgrading stock cables for a LPS?


My thought is no. But I may end up with an extra good quality PC so curious where it may be put to good use, if at all.

I have a 5v LHY LPS for my streamer and a Goldnote PSU-10 for my PS-10.

macg19

@macg19 - from what I can see the Node N130 has a mains 2 pin power socket

  1. did the LHY LPS noticeably improve performance?
  2. I have the Node 2i and I have replaced the stock power cable with an excellent DIY cable of my own design - it significantly improved its performance

You could try one of your existing Zavfino PC’s on the Node N130 by buying a 3pin to 2pin adapter like this one

FYI - the power cables on both my Node 2i and my Simaudio Moon phono stage use solid silver wire for the Live conductor to maximize their details and dynamic performance.

  • whereas the power cables for my amp and power distibution box all use OCC copper conductors

Regards - Steve

@macg19 - thanks, hope you can make use of the info

If  you have some spare time - take a look at

https://forum.audiogon.com/discussions/duelund-conversion-to-diy-helix-geometry-cabling

  • to see what others have contributed to the Helix Cable design - it's a bit long. but some good info also

The photography - thankfully, I'm not as passionate about the phtography as I am cables - that might get me thrown out of the house 😉

Why are mens hobbies so damn expensive - needle point next🤣

Cheers - Steve

@williewonka Ha!

About the LHY LPS: Yes, SQ improvement was not subtle. The upgrade requires replacing the internal powerboard as well as adding an outboard LPS so there is no need for adapters. 

I replaced the cheap PC to the LPS with a good quality PC I had on hand and that helped too which surprised me.

PS: FWIW All in My Digital source cost about $3700 including NOS Mullard’s, isolation base, vibration control, cables and LPS.

It sounds pretty good and very satisfying when compared to my much more expensive analogue source.