Cable management....crossing at right angles or

I simply try to keep mine from actually touching each other. It’s basically impossible not to have a wire cross here or there. The only cables I try to isolate as much as possible are my phono connects. Other than that, it is what it is. I wouldn’t worry much…

Well, @nonoise ...rats kinda find them pleasant, but.... ;)

@mitch2, the pipe insulation is likely the lowest cost option for cable lifts. 👍

I've been trying avoid a major revamp of my 'nest', the worst of which is the 5 pairs of speaker lines that at one point cross a 3' w. 'path'; for lack of a better term...

The Plan (at this time, anyhow) is to sequester the speaker lines, the ac  and dc distributions, and the ic's as much as practical.

The speaker lines can be run straight down from the amp, under the 'rack', and run parallel to the various 'n sundry....

The ac/dc lines can drop vertically to their 'distribution means'; separate the more discrete audio items (amp, pre- and 'pre-subs' {eqs'), 'puters [2], and anything else of it's ilk), keeping in mind the power 'draws' each may use...

CD, TT's, tapes, and their peripherals' with their own power source...

All the 'signal' cables are essentially above all this, physically and conceptually...

Those of themselves could still be a nest of sorts....🤷‍♂️

I'm hoping for a 'cloud effect' visually....with the occasional detail of reasonable rationale....*L*

A variant of the 'foam tech' could look kewl in it's way.....'pipelines' leading to the 'sprayers'....;)

From bitter experience it is clear that cables move around in the night and tie themselves up in impossible knots. FACT

Agree that this shouldn’t matter - other than phono cables. If you’re really experiencing a problem or want to be anal - a little trick from the world of Fire Alarm  notification wiring - where this does happen often and is heard. It requires custom cables. Use a shielded cable. Decide which end has the larger transformer / ground sink. Land the shield on that end. On the other end, pull the shield back a couple inches over the insulation and make certain it’s not in contact with anything.  Always twist your pairs. 
 

it helps to know what your up against - AC induction vs RF interference. Either way, FA guys have been doing this for years. 

Thanks to everyone that responded, I'm really not obsessed with it. I was just curious if there was any way to better isolate things than what I'm doing.

It is good(?) to know that other people struggle with the same thing trying to just get their cables organized and it is just about an impossible job. That's why I wondered if there was anything to help.

Awhile back, I had some sheets from 3M that has some kind of shielding that I used, but of course those disappeared both from my supply and also from the marketplace. So I'll just happily move on and relax. And listen, like we are all supposed to do, right?