Thanks for citing my statement, Lowrider. It comes from this 2011 thread.
I should clarify that what was being discussed in that thread was not diagonal connection of a single pair of conductors, used with jumpers, but rather a biwire set of four conductors, with the two conductors corresponding to one polarity (either + or -) swapped at the speaker terminals.
What I said would not be applicable to a single pair of conductors used with jumpers, and connected to diagonal terminals. The difference that would make in terms of current flow would be that both high frequency currents and low frequency currents would flow through one and only one jumper, while if the two conductors were connected to a horizontal pair of terminals currents in one of those frequency ranges would flow through two jumpers, and currents in the other of those frequency ranges would flow through no jumpers. I have no idea, though, why that might make any difference sonically, provided that contact integrity is good and that the jumpers are short and of reasonably good quality.
In any event, I think that the bottom line in all of this was captured in the initial response by John (Jmcgrogan2), when he said: "You just have to experiment with the cables and decide for yourself." Or as I have said in some other threads on biwiring, in which I stated what I perceived to be the consensus of many discussions on the subject: "It may or may not make a difference. If it makes a difference it may or may not be for the better." :-)
Best regards,
-- Al
I should clarify that what was being discussed in that thread was not diagonal connection of a single pair of conductors, used with jumpers, but rather a biwire set of four conductors, with the two conductors corresponding to one polarity (either + or -) swapped at the speaker terminals.
What I said would not be applicable to a single pair of conductors used with jumpers, and connected to diagonal terminals. The difference that would make in terms of current flow would be that both high frequency currents and low frequency currents would flow through one and only one jumper, while if the two conductors were connected to a horizontal pair of terminals currents in one of those frequency ranges would flow through two jumpers, and currents in the other of those frequency ranges would flow through no jumpers. I have no idea, though, why that might make any difference sonically, provided that contact integrity is good and that the jumpers are short and of reasonably good quality.
In any event, I think that the bottom line in all of this was captured in the initial response by John (Jmcgrogan2), when he said: "You just have to experiment with the cables and decide for yourself." Or as I have said in some other threads on biwiring, in which I stated what I perceived to be the consensus of many discussions on the subject: "It may or may not make a difference. If it makes a difference it may or may not be for the better." :-)
Best regards,
-- Al