New blog post: Living with Focal Speakers

You don’t have to destroy the speakers to experiment with a different Xover. Testing with an outboard xover board is pretty simple.

Especially when the speaker is ported! :)

I really encourage modders to either A) Keep it simple and swap maybe the tweeter or mid range caps or B) Think about the entire crossover design.

The Focal profiles for instance had many resistors and caps in the bass section which could have been swapped, but what they needed was to remove all the resistors and add an inductor to raise up the impedance while keeping the frequency response constant.

My point is, if you start thinking of doing much more than simple cap swapping you should step back and consider starting from a blank sheet.

@erik_squires 

I admire your knowledge and abilities, but I am guessing that, like myself, 90% or more of the members here would have no idea whatsoever of how to modify a crossover, and if they did, they would need to have the measuring equipment to do so like you do. 

I've done simple part-swapping and wire replacement on several speakers, but I think that even that is beyond the comfort zone of most here.

@roxy54 It was a very small part of my blog post, but ss you can see here it is a popular topic of discussion

@erik_squires 

I think that your blog is very interesting, even though I have never owned Focal speakers. I was only commenting on that specific aspect. I apologize if my comments were taken in the wrong way. 

@roxy54  No worries, not everyone enjoys the hobby the same way.  Some parts are for some folks.