2. digital
  3. 1223851196

Anything new with digital room correction?

Last time I tried DRC I was not too happy with it.
It was TacT Audio RCS 2.0, although it did the job and took care of LF problems, it robbed music of transients, dynamics and details were seriously affected.
Is there DRC that would allow you to specify range in which it works, for example deal with 400Hz down, and do not touch I any way anything above 400Hz?
sashav
acoustat6
357 posts
 
Hi, Shashav said, "I measured it using TACT".

Thanks for answering.
Job well done!

Bob
ltmandella's avatar
ltmandella
158 posts
 

[[The biggest problem is (as you say) it robs the sound of dynamics and subtlety. The frequencies that suffer the most are the midrange and treble.]]

 

Yep, that was exactly my experience with the DEQ2496.  And I _really_ wanted a digital EQ/room correction solution for my system.

I pulled it out of the closed and tried it again this week.  Nope, back in the closet it goes . :(

greg_f
106 posts
 

I have been using a Trinnov ST2 Hifi for over 12 years. It is only used in the digital domain between sources and my DAC, it has lots of optimization options and it is extremely flexible. The firmware has been steadily improved and I just couldn't do without it in my room. I use it mainly for the bass response and time alignment of the units, it really is one the best DRCs available.

greg_f
106 posts
 

Btw before the Trinnov I was using a TacT RCS 2.0 myself, there is no comparison between the two. The Trinnov is so much more capable and advanced.

scottwheel
184 posts
 

Are you using the new Waveforming DSP with the Trinnov? That is very high on my radar

More to discover