Same here I just placed an order for an Expanded power cable with the ground/braid upgrade. Cap said it is well worth getting it if you can swing it. Improves it even more. Look forward to see how it compares to the Elite 3.
Audio envy - dang!
I usually post on AG when I have an issue or concern, so I’m happy for once it’s to praise a new product, in this case Audio Envy’s IC.
I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.
I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s
Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.
The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”
And that’s just what I did.
I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.
I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s
Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.
The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”
And that’s just what I did.
- ...
- 336 posts total
SP12's arrived and I finally had a chance to hook them up. First, I followed the arrow to the speaker recommendation for a warmer sound and the bass was just too bloated for me. I reversed them and the bass response improved. I'll give them some time to break in and report back with how I like them. |
@evank Talk or email Cap he is very helpful in explaining his cables in and outs. I had some similar ribbons that were fatiguing and took about 75-100 hours to sound excellent. Of course your cables are different as is your system. Good luck. Love his power cables. |
The captain responded and helped my situation. Just to help anyone else in the future both his suggestions helped. here they are.
Try the configuration with arrow of the positive wire, facing toward the speaker. Then position the arrow of the negative wire, facing towards the amplifier. (This should be the least forward sound.)
What is the positioning and spacing that you have between the wires leading to the speaker? this will also affect the tone.
Cap
Most of the testing that we did is with the cables stacked on top of each other, 1 to 2 inches apart.
I would experiment with separating them 3 inches apart, and then gently move them together until you find your desired tone. It’s possible that having them extremely separated, could work in your situation. It would likely pull the mid range back. But other anomalies can happen with it.
Cap |
- 336 posts total