Swiss Digital FUSE BOX Question Thread

@thyname 

Black Friday 

:)

Best wishes 

Mark 

Can you take the fuse box... out of its box... so you can wire it in directly into an amplifier chassis? Wired directly to the IEC inlet! 

Or is it potted?

I have an amp with 1x fuse on the inlet and 4x fuses on the amp boards. I have in the past run magnetically directional sluggos on the amp board and it made a large difference in sound.

Going back to normal fuses was a noticeable downgrade.

But if I could hardwire in a device like this I would remove not just the fuse but the fuse holder and jump it with good hookup wire (like VH Audio UPOCC).

This will sound better than any sluggo.

Good Morning 

@ agisthos

I am aware today or two guys doing what you have suggested - we understand the reasons - but don't really love this for the obvious reason. Safety First

Here to help 

Many thanks

Mark 

I have looked at these with great interest. However, a bit put off by needing the additional AC cable from the SDFB to the IEC.

It's great to know that it is possible to hard wire it in. I understand the "safety" position as a manufacturer. There are those of us that can and others that can't (or shouldn't). It would be nice to have an option of purchasing SDFB's with hard wire pigtails or terminal pads for direct installation.

One option might be to provide the SDFB's with a hard wired captive pigtail thus eliminating one AC junction.

Another option would be to build the SDFB onto the back of an IEC. (Similar to what CorCom does). I understand that this would require some technical expertise to install, just like a fully hard wired version. But would eliminate multiple contact points of a "conventional" SDFB substitution.

Some suppliers have a "DIY" section with products available for those that can.

@jadedavid 

We set out to make the integration as seamless as possible for the many :)

There are several ways to approach this and we are comfortable offering our SDFB Package the way we do 

Many manufactures have contacted us about building this in - we will go that direction too in 2024.

We have an updated model that will be useable from 10 amps + to 32 amps. The parts we were waiting for are now a reality 

We are also looking at a Hard Wired Option. I like that idea 

Between this product and our new SnubWay we think we have a seriously good path forward - those interested an find Viet's Intro Video here

Thanks