The speakers are Cain and Cain single horn Ben with 8 inches drivers by Fostex, 8 inch constant or minimum impedance
- ...
- 16 posts total
The bottom processor link below may have preamp capabilities. You would have to contact them directly to verify. Links one and two are to balanced analogue crossovers and links three and four are to crossovers with DSP processing. https://www.jlaudio.com/products/cr-1-home-audio-subwoofer-crossovers-96020 https://dbxpro.com/en-US/product_families/crossovers https://dbxpro.com/en-US/products/driverack-pa2 https://www.xta.co.uk/products/4-series/
|
@alanpiga If you are using a powered sub it has all the bass management you need, which is why preamps don't have it.
|
@atmasphere @alanpiga - According to the manual, the 1000X assumes that line level and XLR inputs are going to come from the LFE output of a home theater processor and the internal crossover is bypassed. So some form of external bass management IS required if using this input. The speaker level inputs, on the other hand, do use the built in crossover, so you might just want to connect it this way. If you really want to use the line level input (either RCA or XLR), then you will need a preamp (or processor) that includes a subwoofer crossover. The ones that @audiorusty mentioned are a good place to start. I have a Danville Signal dspNexus that I've been playing with. This will handle what you are looking for, but is primarily designed for full active crossovers (i.e., replacing the passive crossovers in your speakers and using separate amps for each frequency band). It is quite powerful though. |
- 16 posts total