Accuphase E-260 Voltage Conversion (100V to 230V)
I have an Accuphase E-260 Int. Amplifier wired for 100V wall outlets. I am trying to convert it to 230V. From various threads on this forum, I could figure out that this unit has quick connect terminals for winding wires. It was less daunting to find that out!
Can somebody pls help with it's 230V wiring diagram?
(attached: existing taps for 100V wiring)
https://drive.google.com/file/d/1NBny4a2HoLRjfVGiasG48A2IoPaIcI_c/view?usp=sharing
https://drive.google.com/file/d/1N3QUV-7IBBPu5Qtk-_gk2Sw4zPJq82Vk/view?usp=sharing
Thank you.
Abhishek
- ...
- 31 posts total
Post removed |
Hi @imhififan i just have a question regarding the conversion on the e-270. Thanks so much. |
Pins 2 and 4 are not connected to any part of the circuit, they are there to house unused wires. So it doesn’t matter if the black and orange wires are on pin 2 or pin 4. Connect the yellow and brown wires to pin 3 to set the voltage to 120V. Hope this helps. |
Thanks so much @imhififan does it matter which wires go on top and on the bottom of pin 3 ? Thanks again for your support
|
- 31 posts total