From the page you sent me, click on "visit the preffair store...you will see the one. Spiral stripe on grey. Select the metals for connectors and the length you need.
A stupid question(s) about power cords
As the title indicates, I admit that this is probably a stupid question. But since I don’t know (for sure) the answer, I am asking it anyway.
The recent power cord thread got me interested in a power cord upgrade (from the stock cord) on my Maranzt SA10 (SACDP). The power cord receptacle on that particular component does not have a male equipment ground pin--only the neutral and hot pins. Therefore the cord supplied by Maranzt is a two pole (if that is the right terminology) cord. But because I have done it this way before, I do know that it will accept a power cord with an equipment ground as well as a neutral and hot.
Question 1: I went to musicdirect and looked at some power cords and I saw one (an open box Audioquest NRG Z2) that they were calling a two pole cord. The end that plugs in to the component only has a neutral and a hot, but the other end, the end that plugs into the outlet in the wall, does have an equipment ground blade (so that end has three blades). Why would that be?
Question 2: (and this is the stupid one) if a power cord has an equipment ground pin plugged into the wall, even if it is not plugged into an eqipment ground in the component itself, that cord is still connected to the neutral bus bar in the panel, right? So that being the case, since the equipment ground wire in the cord is right next to the hot wire, is there a way unwanted stuff (rf or whatever, my understanding of this is quite limited) can that dirty up the power that is traveling on the hot wire in the power cord?
I think that the answer to the last question is probably going to be ’no’? And if the answer is ’no’, that means that I really don’t need to shop for only two pole cords, right? And I see this as sort of important because if I buy a two pole cord, the ONLY component I can use it on/try it out on will be my SACDP--there will be no playing around with a two pole cord on my preamp or my amp.
And ALSO, if I don’t feel constrained to shopping ONLY for two pole cords, I would probably have more options to consider.
TIA for legitimate insight to this, and to all others, feel free to ridicule me and my question--I don’t mind.
- ...
- 163 posts total
@mrdecibel , it must be this one? |
@hasmarto , I was not saying that they didn't. I was just asking if there was a downside to having an equipment ground wire connected to the neutral bus bar if that neutral ground wire was not needed (as it would not be connected to the component). I didn't feel that this should be an issue, but who knows--I have been wrong before about stuff I was reasonably confident about. That's why I asked. |
- 163 posts total