Ethernet cables

I agree with @rcm1203. Replace all your Ethernet with cat8 cables from Amazon. They’re all triple shielded and will definitely improve things. And they’re good for 10G. I changed everything in my house to Phizli. Cost is only pennies more than your average cat6.

I have a 4 server 2 desktop plus Orbi 960 system running up to a full 10G across a Dell 8024F switch. Cleaned up all my streaming stuttering issues too (Sonos) .

Also don’t go with your isp routers. They’re useless and can provide you a decent firewall and high speed at the same time.

I’m possible way above most of what people are using in that I’ve got a 2.5Gb symmetrical fios feed from Ziply (I’m in Washington), use a SonicWall TZ470 for my router/firewall, and use various multi-mode (1/2.5/5/10) and single mode (1G) SFP+ GPICs as the switch is a 24-port SFP+ switch (I use Cisco, SonicWall, Finisar)

Except for audioman58's spew of absolute nonsense, I am so glad that no one on this thread has suggested $500+ snake oil Ethernet cables.  It gives me hope for this group! 

@lovehifi22 I have mine plugged into EERO access point. Then Purist Audio Cat7 from Silencer into Aurender N200. I’ll be honest I could barely hear any difference with and without the iFi unit in the chain. Tried it into the Aurender as well. I figured cleaning up the signal right at the EERO output made most sense to me. Keep in mind the results will vary based on how good the Ethernet implementation is in your streamer. Aurender happens to have a solid isolated implementation and I attribute the very negligible change to this. I never tried using two Silencers since the results with one were barely, if at all, audible. I left in because 1) it’s not expensive and 2) it did no harm. But again, pretty sure the results will vary in each installation. Try one first. You can return it if it doesn’t work.
I also second @lalitk on LinkUp cable recommendation. Excellent cable that’s solidly built and doesn’t cost an arm and a leg. I have this cable and can say it’s a bargain. Not as detailed and lively sounding as the Purist but also not as expensive. 

+1, @audphile1 

The effectiveness of LAN filters largely depends on the implementation of Ethernet in your streamer and home network. I’ve used tested few of these add-on filters including iSilencer, iSO-Cat7 and Net Isolator ahead of N20 or N30SA….I couldn’t hear any appreciable improvement. I am also using a very high quality Ethernet switch ahead of my N30SA, another possible reason why these LAN filter were so ineffective in my system. 

Thanks everyone for your input. As per usual, the opinions ranged from the naysayers to the over the toppers. One cable that has not been mentioned here is the Supra CAT 8 ethernet cable. Jay Luong at Audio Bacon was very impressed with it even in comparison to much pricier cables. See page two of his cable reviews.

I think that I will order one Supra cable and one Linkup cable for comparison and then go from there.