Step Up Transformers….Are they Worth the Trouble?

I own two SUTs now, a Quadratic MC-1 and an Ortofon ST-80 SE.

Previously I owned a Musical Surroundings Nova III phono stage with linear PS I used with Ortofon 2M black, Benz Micro Glider SL, Ortofon Cadenza black.

With six months of warranty left, it developed a “hiss.” This was audible from 6 feet away - over my tinnitus and presbyacusis. No combination of changing wiring, interconnects, ground wires, preamp/amp/speakers made it go away. DEFINITELY in the box. Tried changing settings, cartridge, turntable… you see where this is going.

First, I was ignored - sending an email for record keeping - then I called, then an “engineer” emailed asking for a recording of the hiss. Which I did. No answer.  Weeks went by, still no answer.  The heck with it. I sold it on eBay for 60% of what I’d paid for it after buying the Quadratic SUT. Buyer had no complaints.

Can’t beat solid state - REAL “solid” state wiring and jacks - for component noise limitations.

I used the Quadratic for most of a year, it was a great match to the Benz AND the Cadenza, then i found a “fell off the truck” deal on an Ortofon Verismo and a few months later a similar deal on the Ortofon St-80 SE SUT.

Simply sublime.

And NO “hiss.”

Wouldn’t go back to a box of electronics for a phono stage if you gave me one… well, I’d keep the SUTs handy just in case.

Hi

I have the EMIA silver sut and the copper phono preamp, very happy with both. 

Who isnt lustining after the etsuro.. ha

Keith

All audio transformers have to be properly loaded. This is important so as to allow for the flattest and widest frequency response.

The correct load will vary with the source impedance (the cartridge) since transformers transform impedance (they don't isolate impedance!).

If the SUT is designed for a particular cartridge the right load is likely 47KOhms with a bit of capacitance (100pf is typical; that assumes about a meter of low capacitance tonearm cable). 

But SUTs designed as a generic such as Lundahl or Jensen (who publishes the correct loading values on their website) need a specific load which will be different for each cartridge used. If you don't have it loaded properly its a good bet you're not hearing what the SUT can really do.

I find that while you can get the noise floor down really low using SUTs, its more musical if you can run direct-in. But how that works with the preamp I'm using will not always be so with all preamps. So you'll have to try it and see. Just keep in mind that the loading thing is pretty important- its not plug and play in many cases!

What many do is to load the SUT incorrectly and then conclude that the SUT is lacking in some way.  Being a transformer maker is not for the faint of heart.

@atmasphere 

Good point, I am focusing on ‘custom’ SUT’s that are designed specifically to mate my choice of the cart’s.