@OP At $3k, provided all the drivers are in perfect condition, they are a bargain. but you need to listen to them properly set up to see if they are for you. Forget about trying to use SET amps with them - they need an amp with a big psu and lots of current. You can never go by a speakers' efficiency numbers without relating it to its EPDR. Wilsons and B&Ws are two examples of nominally efficient speakers that do not work with low power/low current amplifiers.
Wilson Watt 3/Puppy 2 Loudspeaker
I was tempted by a highly discounted used pair of these, and I know JA gave it a very positive review. However, I’m curious about what Audiogoners who actually own them think. I’d appreciate it if you could share your insights. Thx.
https://www.stereophile.com/content/wilson-watt-series-3-puppy-2-loudspeaker
- ...
- 24 posts total
@deep_333, Dave Wilson was far from incompetent. At the time, the Watt/puppy was one of the best high end speakers available. You should be tarred and feathered for your insult to Dave Wilson. |
Well, the speaker’s measurement indeed looks like a guy with a zoology degree tried to engineer them. His rambunctious fans are learning some hard truths today, it appears.. thanks to John Atkinson’s measurements.
|
Wilson claims to stock replacement drivers for all their products, new and old. No clue what they would cost.
I am driving a pair of (admittedly much newer) Wilson’s out of their watt/puppy lineage using Odyssey monoblocks. The result is so good I have so far resisted the temptation to spend huge money on replacement amps. |
- 24 posts total