@phill55 does your Node have a USB out? If so, why wouldn’t you use that instead of spdif?
Can't get Bluesound Node to connect to DAC via iFi iPurifier2 ?
Hello, I am hoping that the collective wisdom of this community can help me figure out what I am doing wrong. I have Bluesound node as a streamer going into Audio Mirror Tubadour III SE via DH Labs 750 Silver Sonic RSA coax cable. The Dac connects via RSA to a Topping Pre90 for volume control back to my Audio Note Oto SE. This configuration works fine when streaming Quboz music. I then decided to add a SPDIF iFi iPurifier2 to the chain. I connected from Bluesound Node Coax input (they only have one) via DH Labs cable to the input section of the iFi Purifier and then connected the iFi output to the Coax input on my AM DAC. When I go to set the AM Dac to Coax, nothing comes out and the light that normally lights up to confirm the Coax selection isnt lit. Similarily, I tried to use Toslink DH Labs optical cable connecting it as well from the iFi optical output to the optical input on my DAC. Again nothing. But when I take the iFI iPurifier out of the link and do just coax Bluesound node to DAC, no problem - it sounds great. I was just trying to see if the iFi would take out some of the jitter from the Bluesound node before it went to my DAC. Any ideas, suggestions would be appreciated. And yes I did turn the complete system on and off to see if the Bluesound Node would recognize the device in the digital chain. Thank you again !!
- ...
- 18 posts total
that is incorrect. |
Vlad the Impaler wants $1K to place a buffer in a digital outlet that you won’t be able to use? What a guy.
I don’t want to sound like an a—hole, and I realize that it isn’t my money, but I would cut bait. Sell off the DAC, Node and iFi component. use the funds to buy a streamer DAC that will easily best the Node. The new Cambridge Audio series, which I think uses the same ESS chip as the Node, could probably be purchased for what you will make by selling the current setup. As someone who has owned both the Node and the CXN 100, I guarantee you that CA does a lot better job at implementing the chip.
|
Speaking of the DAC in the Node, is it possible to use the iFi device without the external DAC and just use the internal DAC in the Node? The Node would have to output the stream to the iFi and the iFi would then send it back to the digital input of the Node. If that is possible, and if that works, then at least you know that the problem is with the iFi-AM DAC interface |
- 18 posts total