Interesting! Kudos to you @erik_squires. Is there extra functionaity in the Dayton piece that makes it worth it. I already have REW but have not used it for this. In fact, I was not aware of this capability.
Impedance - The most ignored and useful measurement tool
I’m constantly reading about audiophiles diagnosing their speakers or attempting to mod their crossovers with expensive new parts. The one tool I wish they’d all get and rarely do is an impedance graphing tool. These are either nearly free or affordable.
They let you produce impedance charts like Stereophile does, as well as measure capacitors and inductors with ESR/DCR respectively.
In the nearly free variety you can build one and use Room EQ Wizard. In the affordable is the Dayton Audio V3. Either one does an excellent job of measuring a driver, crossover parts and the entire speaker as well. Completely irreplaceable tools.
Diagnosing your speakers with the help of others on the internet is made so much easier when you have one of these. Even if your speakers are fine, measure them and keep the charts handy for when they do go bad, it will make it much easier to understand what is and is not working. Replacing a cap/coil? Measure them and the speaker before and after when you are done to make sure everything came back together properly.
You’d be surprised how many speakers have a woofer or tweeter that has stopped working but the listeners don’t even realize it. These are immediately visible problems in the impedance plot.
Of course, it's just a tool, but when a driver goes bad, or a solder joint fails the impedance charts will go wildly off track. It's up to you to dig in and diagnose further.
- ...
- 21 posts total
YES @erik_squires !!!!!!! |
I was talking about this yesterday with @decooney -- the usefulness of knowing speakers' impedance loads. We were discussing how much class A power would be optimal for speakers. |
@sns Great point. In both the case of Fritz's speakers and my others, Ascends, the builders (Fritz and Dave Fabrikant) wrote to me and explained about the kindness of the phase angles in their designs and how their speakers would work with a wide variety of amps without much trouble. On the other hand, when I was auditioning some other speakers, a couple years ago, @tvad helped me realize that the Focals were not sounding great because of a terrible, sharp dip down to 3ohms. I could not have understood it without the phase angle concept. |
- 21 posts total