I’m considering upgrading my speakers internal wiring

My speakers sound so good I get stuck in front of them for hours, cutting into my time translating Greek philosophy back into Greek, and working to help the extremely wealthy with their personal issues. I'm going to replace their (the speakers, not the extremely wealthy) classy internal wire with rusty old lamp cord to dial them back a little.

When Peter lived / worked here in Alpine, he was a guy you could have a beer ( the last time i recall w him… he had a hard Cider… )… i would just call him… Unconstrained by $ his answers will likely change..

Also, the last pair of PbN speakers i heard did have a plexiglass back exposed filter network with absolutely nothing to be ashamed of… just my opinion…

@wolf_garcia I have ( somewhere ) 50’ of brown lamp cord circa 1965… copper was great again back then… Mac and Bozak endorsed..

Greek is all Greek to me, i specialize in Latin, in particular the prayers for cooperative electrons… likely a Greek thing.. after all

I replaced the internal wiring first before I upgraded the crossovers , this allowed me to experience the change only of the wires .  I used Cardas chassis wire , first I used 15.5awg from speaker posts to crossovers and then to the speakers , I then changed to 17.5awg from the mid and tweeter crossover to the speakers . The origianl wiring was 18awg solid wire .  I like the sound improvement alot but working with cardas wires means using a solder hot pot which is a little more work . 

If your crossovers have Clarity capacitors that's great , I used the newest Purity series on the mid and tweeter and CMR , MR on the woofer ( I upgraded the woofer first before the Purity caps were available ) .  You should also consider replacing the resistors with Mills , I had done this after the wiring and before the capacitors ( I tried to listen to each form of improvement independently rather than doing the upgrades all at once ) . I used the original inductors  do to size .  I also installed Cardas speaker binding posts although if you have the funds WBT posts might be better .

Good Luck

@bobbyloans 

Quality of internal and external wiring is meaningful in all of the components in our system.  I would say the odds are very good that you would find internal wiring for your speakers that would make a noticeable improvement,  

However your system is likely already tuned to your liking and introducing another variable in hopes of improved sound is not a sure thing.  

Since bulk cabling is relatively inexpensive I would suggest you buy at least (3) different brand specs of wiring and give each one a trial.  

Once you find the one you prefer, I would even solder the wire directly to all terminals.  

Lots of work but how would you feel if the first set didn't work out?