Here's another related thread that may be of interest
https://forum.audiogon.com/discussions/what-i-have-found-makes-a-good-cable
DIY Helix Geometry Cabling
Apologies for the delay, but it’s been very difficult to find a FREE platform to host the Helix DIY AIR Cable content that works with minimal hassle.
The cost of running the original web site was getting expensive, so I had to pull the plug on it
The new content detailed below consists of a series of PDF files that are derived from the web site content.
A special Thanks to Mikhail for hosting the PDF files on GitHub - very much appreciated
Please feel free to copy the PDF files for your own use or distribute to others - OR - you can just access the content from the links below.
Going forward...
Below are the sections from the web site that applies to the Helix DIY cable designs
THE HELIX IMAGE Power Cable.pdf
The HELIX IMAGE Interconnect RCA and XLR.pdf
The HELIX IMAGE Speaker Cable.pdf
Cable Science - Some Basics.pdf
The Significance of Cable Architectures.pdf
Hope this provides the information that people were looking for
Regards Steve
Post removed |
Here's another related thread that may be of interest
https://forum.audiogon.com/discussions/what-i-have-found-makes-a-good-cable |
For the 5v USB conductor I used this shielded conductor. I think I used 20 gauge, but this is fine also. I simply don’t recall 100% on the gauge. I do think shielding is important in a usb cable on the 5V. I would run it outside of the helix coil. I little tricky, but can be done. I have made some so I can unplug the 5v conductor with a small connector a few inch up from the usb connector if the 5v is not needed. |