Squeezebox Touch: jitter thru wi-fi?


I'm looking into a SB Touch to go with a non-dedicated PC, and to feed my preamp (so initially, I'll use the Touch's DAC).

Eventually I plan to buy an external DAC, and I'm interested in the asynch USB DACs, which are supposed to avoid jitter through that interface. There's a Touch tweak going around to turn the USB input into an output, so that would be a preferred way to connect to said DAC.

Now how about mistimmings in the data transfer (jitter) through my wi-fi from PC to Touch? Is that an issue?

Thanks!
lewinskih01
The worse case for two channel spdif is 24bit at 192kHz.
24 bit data is transferred in 32bit packets (8 bit preamble).

32bit x 2channels x 192kHz = 12.3Mbps

802.11g runs at up to 54Mbps while 802.11n more than doubles it.
Kijanki,

54Mbps is what wireless g can do optimally based on the spec I think, right?

Weak/sub optimal signals reduces that bandwidth.

Also I've found not all g routers are the same. Actual bandwidth at a particular range seems to vary from router to router. There may be many reasons for this

Processors and programming can vary.

Differences in the performance of the radio transmitter /receiver technology may be another factor. Antenna's used are one factor. I suspect there are others also.
802.11g runs at up to 54Mbps
Not in the real world. 15 mbps would be a reasonable expectation for a fairly optimal setup, and I'm sure that less than 10 is not uncommon.

I don't have a feel yet for typical 802.11n performance, but given that the theoretical maximums that were advertised for a, b, and g were all essentially fictional, I'd be surprised if the same didn't apply there.

Best regards,
-- Al
Al, I've never done the math or quantitatively measured bandwidths, but from what I have seen I suspect your real world estimates to be reasonable.

Wireless n probably also does not always perform to the max based on teh spec but I would expect perhaps still a significant improvement over g in practice.

I have a wireless n router but my server and players are all wireless G, so I have not really leveraged the current wirless n technology in practice to date.

Again, just to be clear for all, these are limitations that determine how fast digital data can move through the digital wireless "pipeline" as input to the Squeezebox. Jitter is not a phenomena that pertains to transmission of dogital data. Jitter comes into play during the DAC process. Data input to the DAC process is provided by the Squeezebox, regardless of whether the SB's internal built in or an external DAC is used.