Wyred 4 Sound STI-500 Breakin Time

I agree with the balanced comment, you're missing out if you're only running single ended.

I own the STI-500 and the DAC2 and it did take quite a long time for the STI-500 to sound its best. But if you're missing detail, that could be something different. Presenting fine detail is one of the many strengths of the STI-500 so maybe it doesn't like the same cables (especially power cord) that the Bada gear liked.

The speaker cables and the power cord seem to work as a team, so consider that. And the interconnects play a part as well. Are you using a good quality AC line conditioner? If not, you should be.

Also, I'd change from the variable output to the fixed output on the DAC2 if you haven't already done so.

You might also move the roll-off setting of the digital filter one notch up (to 50k, I believe) as that will extend the highs and apparent detail a bit.

It's hard for me to imagine that the Bada gear could give as much detail as the STI-500, let alone more. But combinations of different gear and cables are virtually unlimited, so anything is possible, I suppose.

Some great comments, thanks. Here is some additional detail:

I now have about 100Hrs on the STI-500 and just beginning to get the detail that I got with the BADA amp and preamp. I was really sweating it after paying the price for the STI500 but the reviews have been soo good and the DAC1 was terrific.

Interconnects are balanced from the DAC2 to the STI500 using Morrow cables - I believe they are the M1.1 balanced. They were spectacular from the DAC1 to the BADA preamp. Made a huge difference over the other cables I was using.

I have Magnepan 1.7s which provide amazing detail and let me know about every change in the system.

I have my fingers crossed but I am beginning to hear the music open up. It never sounded bad, just not detailed. In fact, I find the STI500 warmer than the BADA which had a hybrid tube/transistor preamp. Who would have guessed?

I will be checking the settings on the DAC2 but believe I have them correct.

How long did your STI take to break in?

I am not sure but as I was also breaking in my speakers Dynaudio S1.4 at the same time. The whole system (STI-500, and Dyn S1.4) took about 200 hours before they sounded their best.

However, I also find that the STI-500 takes about half an hour to "warm" from standby to play well. It can sound cold, and hard, soundstage flat for the first half hour.

Source is an Audiolab 8200CDQ similar to the W4S DAC2.

Cheers

Good point. STI-500 only uses 10...15W stand-by. It could be turned on 24/7.