Is extremely accurate "VTA" adjustment necessary?

Hey Doug, I can help you w/ the resistors issue. Robert Schult (Ridge Street Audio) chose some really *kick ass* NOS resistors for my phonostage. Besides getting the appropriate 75K loading for my modded Groovemaster, there was indeed a lowered noise floor as Robert promised me.

Raoul needs the internal cleansing. Perhaps I'm mistaken and it's really Alzheimer medication what's really needed. The internal cleansing can't hurt, anyway--neither the *girlfriend*...

Doug: First I don't think I have to start a thread on that subject: if you don't want to share ( for whatever reason ) your points of view on those issues, it is ok.
" re-read the previous....": What specifically do you want to tell me? , it is personal?. Read my last answer to you.
Regards and enjoy the music.
Raul.

Thanks Francisco. I'll check that out once we've nailed down exactly what impedance we want with the Airy.

Raul, Psychic, Jphii, 4yanx: Since all of you seem to missing Romy the Cat so much: Here's a nice treat for you all...

Romy the Cat - Forum

Thanks again to everyone for their responses and back to the original topic of discussion. I think many of the posts have been very informative and really helped a lot in answering the question of importance of micro adjustments of vta/sra. Sorry for not responding for quite a while. Here’s a collection of answers to various posts that occurred during my absence (dating back to 10/8/04)

Doug – Thanks for you very much for your responses and thanks for going back to the article and for taking a fresh and more neutral look at the article. Thanks for trying to answer my earlier question on why don't we hear the variation in VTA as the LP rotates, since this variation is much bigger than changing the arm height by .005'. I agree that it is very difficult to find a satisfactory answer to this question, in particular since you and many others do have systems that are able to resolve very small differences in vta adjustments via arm height. I am quite convinced that it is the actual minor change in the vta or sra angle that causes the audible differences, but I agree that the answer in the article seems not very convincing either. Your observations are no explainable by mechanical rigidity arguments, since changes in the sound that are due to the arm height change would not be as repeatable as they are if mechanical resonance behavior would be the answer. Also the construction of the TriPlanar arm seems to address the mechanical stability question already.

Thomas – I agree that azimuth is an issue that needs to be addressed in fine-tuning much more than vta. In particular since it is not even a question on which angle to choose. Too bad most companies choose to only hand you a mirror. I think there’s probably more people out there arguing and finding solutions to vta that finding good approaches to azimuth adjustments. Maybe a good time to start a new thread about azimuth…

Eldartford – I did not quite understand you comment on measuring the different critical parameters by reversing wires in one channel. Would you mind elaborating on that some more or eventually giving references?

Decay and Greggadd – Thanks for you discussion of measurement vs. adjustment by ear. In my opinion objective and accurate measurements seem almost not possible in this case. The missing knowledge of the correct cutting angle for each record as well as the inability to measure angles to an accuracy of less than a tenth of a degree seems to make accurate measurements impossible. Remember that I was talking about changes in arm height on the order or less than 1/10mm. Although measurements might give a good starting point but the ultimate measurement in this case seems to be the ear. Also one more question that you might be able to help me out: If one tries to adjust for a 2 degree variation in cutting angle, would that not correspond to a change in arm height by about 6mm? These are huge changes compared to the ones we were talking about earlier.

Again thanks to everyone for his or her answers.

Best wishes,

Rene