Cartridge mounting on graham phantom

Dear Strapper: I don't think is an arm wand problem ( you can ask about to the Graham people ).
My experiences with Koetsu cartridges is that are not perfect build cartridges. They have small differences between them.
Now, do you have the quality sound reproduction that you know your system can give you?. If not, you can have to check the VTA/SRA/VTF/Overhang of your analog rig and if you have it, then don't worry about.

Regards and enjoy the music.
Raul.

Got the same problem , second position arm tilt back at begiining or end of disk, arm must be posizioned perfectly with ghaham mark nearest possible to platter. in addition smetime is needed to lower cart putting some spacer below the shell. only way to get out of this problem who was driving me crazy.

Ezio

i had a similar problem whereas my arm height was too high
for my koetsu
i solved this using the cartridge mans isolator.
a thicker platter mat would also have solved this

I used a spacer for my Koetsu as well, but w. a SME V.