Help, Turntable Belt.... Weird

don't use windex.

the problem is the solvents in it and not the ammonia.

I would use a gentle soap and then air dry

(vpi aries owner)

It would really help to know what your turntable is. If it's a VPI with the original (not black) belt(s) , I've had a lot of success with the following regimen: periodically remove the belt, clean the surface of the pulley(s) and platter with alcohol -- I use a cotton ball -- clean the belt with alcohol, BOIL the belt for 30 seconds, let it dry, talc the belt and replace it on the platter. Over a 12-year period with the same turntable (early model VPI TNT) I've never had a belt go "bad" although one or two have eventually stretched to the point where the boiling process didn't bring them back. Incidentally, Mike at VPI suggested the boiling treatment. I seriously doubt that these belts have any rubber in them, BTW, and I don't necessarily recommend the treatment on non-VPI tables. But it sure works for me. Dave

what weird meant is the Windex suggested, the Turntable is a music Hall, but I hope the same rubber as any? Thanks guys will look into it.

It depends on the composition of the belt. If the manufacturer recommends Windex then use it. I service belt driven mechanisms (not audio) all day long and use Windex or generics to clean belts regularly with no ill effects. BTW speed and timing is extremely critical to the equipment I'm referring to.

A little off-topic, but still a good tip. My TT can sit for weeks without being used. To greatly extend the life of the belt, I slip it off during these periods. It’s a small inconvenience to have to slip it on again when listening, but you’ll get years more use before the belt’s stretched to the point of needing replacement.