What Turntable to buy under $600 ?

Someone is selling an alignment disk here at audiogon for about $10 that looks like all you need for set up. Its listed in analog under 'table' and is called 'once'. Think I will be ordering one myself. Shipping is included which is good because its coming from Australia.
Fiddling with the setup is part of vinyl, but usually once its set you can forget at least for a while.

Agree with postings above about the Rega... and think that the RB300 is definitely a best buy--why else do you see it on other much more expensive tables?

Would probably couple it with something in the Grado line... probably at the low end (new to vinyl might increase the risk of damaging a cartridge until you "get the hang of it")--easy enough to move up later.

The GEODISC is an easy alignment tool that pops up every once in a while used. Put it on the platter, point "line AB" at the pivot point and it provides an overhang and alignment for you that's a good place to start. I'd also take some of that money and invest in a cheap balance (for setting the downforce) and a bubble level (buy it at a hardware store, they break in faster than the audio versions), and some way to clean your vinyl.

Then sit back and enjoy.

A P3 is hard to beat at this price point. For an absolutely no-worries experience, consider using a Rega cartridge. Rega cartridges and tonearms feature a three point mounting system so you don't have to worry about alignment. Granted, there are better sounding cartridges than the Regas for the same money, but the Rega cartridges aren't bad, and if you hate to fiddle, they're the way to go.

Based on the majority, the Rega P3 is a top choice. What about the Sota's or VPI models under $600? If I get these set-up at a dealer do they require frequent adjustments?

stock rb300 is pedestrian....rb300 with silver wire and a quality heavyweight (michell, others) moves it into another category....AND defeating the spring loaded VTF and using dynamic balancing helps, too!