2. analog
  3. 1134689340

HFNR and antiskate on SME 3009/III

When I have my SME3009/III set at approx. 2Gm on the antiskate, and listen to the torture track on the HFNR test record, I get a buzzing in the right channel. Pulling gently on the antiskate string removes the buzz, so I equate that to increasing the antiskate.

Well, if I do that so that it doesn't buzz, the darn thing will not cue up on the outside of the record -- the tonearm flies right off the record. (!)

The antiskate pulley has been lined up (per SME instructions) so that it is perpendicular to the tonearm at the start of the record, and fairly skewed by the end. My thought (and it's dangerous when I think) is that the SME instructions are wrong, and it should be perpendicular when the tonearm is at the inside of the record, not the outside.

Anyone else have this issue?
lousytourist
dougdeacon
3,338 posts
 
Agree with all the above.

Nsgarch's visual method works well. (Note: it's better with high compliance cartridges than low compliance ones.) Fine tune by ear while listening to music.

I do have the HFN record. As I've posted many times on VA, the design of its so-called anti-skate tracks (side one, tracks 6-9) is inherently flawed. Do not use them for setting AS.

If you want to use that silly record to rough in AS, use the three, widely spaced "tracking test" bands on side two. Adjust AS until L/R buzzing is about equal on all three bands. Assuming your VTF is correct, that method is valid. The tracks at the end of side one are not.
clio09
3,360 posts
 
I used the Wally antiskating tool to set up my TT. I confirmed the results with the HFNR test tracks. Just out of curiosity I tried Nsgarch's test. This method works as well for me. I even set the antiskate to the opposite setting and saw exactly what Nsgarch was referring to. I can't imagine this not working for any cartridge.
etbaby
138 posts
 
Read the Thornes white paper on setting anti skating. The correct value is 14-16 percent of your adjusted tracking force. Therefore if the tracking force is 2 grams you should sets you antiskate to 0.28-0.32 grams.

Make sure your table is absolutely level in both horizonial and vertical directions
nsgarch's avatar
nsgarch
2,524 posts
 
Etbaby, would you mind telling us where we can find the Thornes white paper? Thanks.
More to discover