Nkj,
I used my Urushi w. an SME supplied spacer to be able to get the VTA negative enough. As a rough guide the VTA should be level to the rear half of the cartridge, which is slightly angled. Use your ear for setting the VTA once broken in. Also, the impedance in my system was set at 100 ohms.
Also, I used blue tack on the arm tube right next to the pivot point & inside the headshell area which did lead to an improvement. Lastly, I hope you are not using the SME included phono cable. There is a tremendous jump in improvement once you upgrade to a better cable.
Hope this helps.
I used my Urushi w. an SME supplied spacer to be able to get the VTA negative enough. As a rough guide the VTA should be level to the rear half of the cartridge, which is slightly angled. Use your ear for setting the VTA once broken in. Also, the impedance in my system was set at 100 ohms.
Also, I used blue tack on the arm tube right next to the pivot point & inside the headshell area which did lead to an improvement. Lastly, I hope you are not using the SME included phono cable. There is a tremendous jump in improvement once you upgrade to a better cable.
Hope this helps.