What is under your TT, cheap islolation?

I made a very simple stand out of 5 pieces of 1" thick MDF, 20 pieces of 2" ABS flanged caps, glue, and 20 cheap inflated rubber balls from the dollar store. Just over a year later, my SME 20/2A and I are still very satisfied.

Hi fishwater,

One extra thing you might try. This is something that was recommended to me since I also use sandboxes (see my system pictures). That is to make a few pieces of MDF or some of the poplar into strips, maybe 1 inch or 1 1/2 inch in width and glue them on edge to the bottom of the top shelf. This way they protrude down into the sand and act like sinks. Picture it like an upside-down heat sink. I'm in the middle of a couple of other projects so I haven't gotten around to trying it yet. It does make sense though.

Best of luck,

Dan

I have no problems with isolation from footfall with my set up. I have a 5 foot tall Zoethecus rack sitting on a suspended wood floor. But, the rack is actually fixed to a nearby wall using angle brackets attached to a cleat that is, in turn attached to the wall. My table is a Basis Debut.

I generally find that lighter tables with spring suspensions to be the most susceptible to problems with footfall. Big heavy tables that have damped spring suspensions work the best. It is analogous to big heavy cars riding over bumps in the road.

For your temporary set up, I would think that the easiest, and cheapest experiment at isolation would be sorbothane pucks. They do a very good job of dissipating the energy from the movement of the floor without itself oscillating.

I found that the energy causing my problem were horizontal rather than vertical. The equipment stand actually rocked very slightly with the flexing of the floor. If that is your problem, you may be seeking stability rather than isolation. That is where the wall cleat might come in handy. Or the wall mount.

My Linn deck rests on a 3/4" slab of slate of the same footprint. The slate sits on three ball-in-cup feet and the whole stack rests on a 6' side table located along a wall. The three mushy feet allow for damped vertical and lateral movement. The slate, about the same weight as the deck, worked better that just supporting the deck alone on the feet. Sending the kids to a friend's house works even better.