Optimal loading for Dynavector xx2


Hi - I have just bought a Dynavector xx2 cartridge, loading it with the recommended 30 Ohm setting, but I have read that 40 Ohm is better suited for this cartridge, any recommendation of where is the right setting?

Thanks !

Fernando
128x128flg2001
I am not familiar at all with the Michael Yee PF1 phono stage.

Is it tubed based or solid state?

What gain levels does it offer?

You will find that the DV XX-2 cartridge performs best with 68 dB plus gain.
The Michael Yee phono satges has 4 input sensitivity options (for MM and MC) and load settings from 20 to 350 Ohms with a combination of 2 8 DIP switches, increments are every 10 Ohm until 150 or so and then 20 Ohm increments.

I have it at the highest sensitivity option (above 575dB) which gives plenty of gain to have it at the same output level as the CDP input option of my preamp, and at 30 Ohms (I will try the 100 Ohm setting and work out from there).

Am I heading to the right path?

Thanks a lot (all) for your help, it is highly appreciated.

Fernando
Yes, you are definitely heading in the right path.

I assume you meant 57.5 dB gain is the highest option available for the PF-1 phono stage.

I found this about the newer PFE-1 phono stage:

http://www.michaelyeeaudio.com/PFE-1.html

They indicate 60 dB gain is the maximum available.

As long as you are matching, the line level stage of your pre-amplifier stage to somewhere just under or near CD input level, you are fine.

The major issue with the DV XX-2 cartridge is the low 0.23 mV output results in -12.8 dB gain and to get to the line input sensitivity stage of your pre-amplifier in use, a higher gain maybe required in most cases from the phono stage, hence the reason I mentioned 68 dB plus, as you are starting in the negative.

Try the 100 ohm loading and report back with your results.
Yeap.. 57.5 dB (575 would be terrifying!!!)

I will try the 100 ohm loading and go back once I return from this business trip, thanks Xlr8or.