Tool kit for cartridge setup

Dear Doug and Steve,
Thanks for the information. Do you have a specific recommendation for a reasonably priced VTF digital scale? Thanks again. I bought a denon 103r for practice before I try tweaking my Helikon SL.
Jeff

.
Jeff,
.
Buy the digital stylus force gauge that is listed on
Audiogon below. It is incredibly accurate and easy to use as well as an incredible value. Several Audiogoners have posted their positive reactions to this scale:
.
http://cls.audiogon.com/cgi-bin/cls.pl?accstwek&1158166832
.
This one's a no brainer and it will arrive quite quickly.
.
Rgds,
Larry
.

I'll second Larry's suggestion. It will be the last VTF scale you will ever need or want.

One thing that I have found to be of a most particularly troubling nature is the starting point. Do you start with the arm level? Or the cartridge body level? Etc., etc. Drove me nuts until Nsgarch (thanks again, Neil!)posted a methodology that is logical, somewhat easy to use and takes most (not all,depending on your eyesight) of the guess work out of this finding of a good idea of the starting position.

This is the thread:
How to set SRA after determining true vertical?

I won't go through it here, but I would say that if after reading that post the concept makes sense you will want to add a first surface mirror and at least a 10x (or a little more) magnifying glass to your tool box.

From there all you need is a good set of ears, either yours or someone you trust, and a tonearm with easy VTA adjustability.

Best of luck,

Dan

Jeff,

I also agree with Larry on the scale recommendation. Best bang/buck ratio out there, and as accurate as you'll ever need. If you want to spend more, you can buy the same scale from Acoustic Sounds for $90 more. ;-)

BTW, you will hear few differences adjusting VTA/SRA with a Denon 103R, so don't go crazy over that particular parameter. The Helikon's elliptical stylus will be more sensitive, so save your arm height fine-tuning for that cartridge.

One of the few areas where Nsgarch and I disagree is the (fairly minor) point of "where to start" with VTA/SRA. Armtube level is easy, no doubt, but it's arbitrary. VTA and SRA are both cartridge/record relationships, so the starting point should be expressed in cartridge/record terms. This gets you thinking about the right thing and lets you take advantage of knowledge gained by previous users of the same cartridge.

Most cartridges perform best when level. A Shelter, however, likes to be slightly tail down while VdH recommends a nose down attitude for his cartridges. I don't know about a Helikon, so the optimal approach is to ask other owners of that cartridge.

The rest of Nsgarch's method is spot-on.

I still don't get it, Doug. In Nsgarch's method you start with the stylus as close to perpendicular as you can get it. Assuming a 1.5 degree (manufacturer depedant) stylus to surface angle is desired, and you change the heighth of the arm to get that angle, how can this not give you a good starting point, regardless of where the arm ends up?