2. analog
  3. 1157059532

Building high-end 'tables cheap at Home Despot II

“For those who want the moon but can't afford it or those who can afford it but like to have fun and work with their hands, I'm willing to give out a recipe for a true high-end 'table which is easy to do, and fun to make as sky's the limit on design/creativity! The cost of materials, including 'table, is roughly $200 (depending, more or less), and add to that a Rega tonearm. The results are astonishing. I'll even tell/show you how to make chipboard look like marble and fool and impress all your friends. If there's interest I'll get on with this project, if not, I'll just continue making them in my basement. The next one I make will have a Corian top and have a zebra stripe pattern! Fun! Any takers?”

The Lead in “Da Thread” as posted by Johnnantais - 2-01-04

Let the saga continue. Sail on, oh ships of Lenco!
mario_b
hot_rod
11 posts
 
Lewm,
I installed the bushing so it actually sits higher than the original spring post to try to mimic the slight upward pull of the spring.
Since the bushing is further away than the spring post the bushing sits maybe 3/16-1/4 higher to mimic the same angle of pull.Seems to be the way to go as far as I'm concerned.
OMR
ml6707's avatar
ml6707
16 posts
 
Hi all, I am using a stock Lenco L75 with a Rega RB300 tonearm and a Denon DL-103 cartridge thru a Denon AU300 step up transformer. I am blown away by this setup, especially the Denon cartridge with its conical stylus. I have ordered the TJN mod from Jean and I am waiting to get it. Question for anyone, is it that difficult to install?

Also, I am curious about the bearing upgrade that Jean sells for $190, what kinds of sonic improvements could I expect from that?

thanks! Michael
dopogue
1,773 posts
 
Re installing Jean's TJN mod kit, I did it by myself in a few hours, and I'm almost 82. A little tricky in spots, but I don't see why you would have any trouble. Good luck, Dave
gilles130
128 posts
 
Also, I am curious about the bearing upgrade that Jean sells for $190, what kinds of sonic improvements could I expect from that?

Hello from France, Michael, i wait for my TJN from J Nantais but have heard nothing about the bearing upgrade.Where have you seen this as i am interested in an upgrade for bearing?
ml6707's avatar
ml6707
16 posts
 
Hi, I asked Jean about the bearing upgrade and he quoted me at $190.
More to discover