cartridge for Nottingham spacedeck / spacearm ho

I went from a Clearaudio Virtuoso Wood MM to a Zyz Fuji MC on my Spacedeck. The most obvious differences were microdynamics (or perhaps more delineation of individual dynamics for each instrument or sound?), as well as greater tonal richness and dimensionality to each instrument/sound.

I'm using Lundahl step ups, which sound fine and cost alot less then the Bent Mu's.

Queg - thanks for the input - di dyou go with the high or low gain version of the Fuji? the Lundahl is this the K&K version?, do you know if it can be hardwired in avoiding another interconnect? Are you using the spacearm or something else?

thanks

tom

I had the high gain version of the Fuji (I've since upgraded to a low output Airy 3x). The Lundahls are from K&K. I hardwired them into a Hagerman Cornet phono pre. It was not difficult, but you'll also want to think about soldering in the right value resistors in parallel to your existing (I assume) 47k resistors so the cartridge will see its recommended load. There's more about cartridge loading and on the K&K website.

I'm using a Nottingham "The Foot" , a 12" arm that was a precurser to the Ace Anna arm. I was advised, and now I believe, that this arm doesn't do full justice to the Airy 3x.

I've since upgraded my phono preamp to a K&K Phono SE, which is very good (and uses the same Lundahl stepups).