2. analog
  3. 1169001985

New Maplenoll Ariadne owner needing advice

I have recently purchased a maplenoll ariadne. I have tried to learn a little about the table but find very little information. I know the table was discontinued in the 90's but the little i have found indicated it is a very good table. I am interested to learn if there are any tricks or problems to optimizing this table. As most of you probably know, it is an air bearing platter and tonearm. I plan on putting my zxy airy 3 on the arm once I get it set up.
oilmanmojo
crem1
672 posts
 
Readers: Todate, the the designer of the Friction Damping Tonearm has yet to make arraignments so that I may purchase and experiment with his tonearm. Perhaps other commitments are taking up his time. I will keep all informed. The tonearm can be viewed at www.tonearm.org.
crem1
672 posts
 
Sorry, the Tonearm designer has withdrawn the design from sale. So that's the end of that.
oilmanmojo OP
472 posts
 
charlie

I am thinking about building a prototype arm similar to the arm on my maplenoll to see if it would have some marketing potential. I will keep you informed as to my progress if you would be interested. It would be an airbearing/linear tracking arm that has full vta/vtf/azimuth adjustablity.
crem1
672 posts
 
Oilman, That would be a killer !!
oilmanmojo OP
472 posts
 
i will keep you informed on the project. Be patient, i work slow. Once i have the design concept down, i will send you a copy.
More to discover