New Maplenoll Ariadne owner needing advice

The plastic plug is not cemented in very well. When i was modifying my arm, i had to tap a new screw thread and found it came out during drilling. There were two plugs in mine. I have also considered replacing the armtube with a solid piece of graphite rod to avoid the resonance factor. Just have not gotten around to completing this yet.

Oilmanmojo : Thanks for the info. charlie

The reason for using Balsa is to keep the overall weight low. Bear this in mind when choosing an alternate material. Perhaps using very high pressure (more than 60PSI) precludes this concern.

Piedpiper: To be sure I understand: The modification suggested is to replace both the arm tube and tone-arm with balsa , rather than to uncap the arm tube to insert a snugg fitting balsa dowel inside the tube ,itself, then regluing the end cap. Should I replace the arm tube, a Woodcrafter store is close and I recall a dowel department-all types. Getting a dowel turned is the tricky issue. I presume the dowel shound be fine sanded, sealed, painted , lightly sanded (800 grt)and perhaps resealed. P/P I understand the weight & pressure issue. Even with a second pump as Oilman I doubt I could get more than 4-5 PSI, presently I 'm @46 PSI. Readers please feel free to express your comments/ideas.

'Nollers : Following watching Jolie in "Wanted", I stopped at the local WoodCraft Store chatting with the store manager "EJ". We discussed the possibility to convert several metal parts on the Ari' into wood. I infrequently visit this place just scanning over stock for ideas. EJ mentioned that a former employee is a world-class woodworker and analog-head. The guy apparently is into turntables and maybe interested in making a few replacement parts.EJ said he would attempt to hook us up. I looked over a selection of exotic hard woods & dowels ; ideas kept popping into the mind-broth. Nothing firm but also scads of solid brass parts to use as end caps , screws, bolts as well as wood inserts and replacement parts for the air bearing tube and tone-arm. Only time will tell how all of this will "turn" out. Its a good day when I can fuse Jolie and audio-play together.