What's the frequency response of vinyl?

Tafka_steve...Flat to 100KHz is not a big deal for electronics. I doubt that my Shure V15mr cartridge goes that high, but it would still be sensitive at 35KHz. However, please note that I am inferring the maximum frequency from the behavior evident below 20KHz, a range where the frequency response of the cartridge is not an issue. An analogy would be to estimate the distance of a baseball home run by observing the height and trajectory of the ball as it dissapeared over the fence.

Has anyone done the half speed experiment? That would provide the best answer. 16 rpm turntables are not common, but a 45rpm record played at 33 would give some idea.

Here's the link to the article about Stan Ricker inadvertently cutting a 122 kHz tape recorder bias frequency on a master lacquer: http://www.positive-feedback.com/Issue2/mastering.htm.

Eldartford, which phono stage are you using that is flat out to 100 kHz? Mine is Lloyd Walker's Reference Second Edition Plus. I've seen frequency response measurements of the Shure V-15VMR (most recently by John Elison at Vinyl Asylum). They measure very flat, but roll off prematurely starting around 16 kHz, due to the high coil inductance resulting in an aggressive low pass filter.

Typical moving coils show a rise above 15 kHz, with peaking around 30-40 kHz. Again, this behavior can be calculated based on the low pass filter due to coil inductance and R and C load parameters. [Hagermann has a website that allows you to see curves with plug in values.] Yes, this shows up as ringing on square waves. But MCs do not roll off highs before 20 kHz like the Shure.

Tafka_steve...I am not sure I completely understood the article, but I think that they cut 61KHz at half speed, which, if played back at full speed would represent 122KHz. That's a lot different from having an actual playback capability of 122 KHz.

Eldartford, the article does not refer to playback capability, only the encoding capability of the Ricker's cutting system and the master lacquer. As I mention in my post of 1/30, I do not know if that signal can be transferred through all the pressing steps to a vinyl record, and I don't know of many cartridges that are rated out to 100 kHz.

In case I did not make it clear, the Shure cartridges are NOT limited by their mechanical parameters. The line contact stylus, extremely low tip mass, and high compliance should permit outstanding high frequency MECHANICAL behavior. The problem is that you never see that at the phono stage, because the Shure cartridges are ELECTRICALLY LIMITED in high frequency response by their huge coil inductance. Duh, some design. It is no wonder that you measure a vinyl rolloff before 20 kHz.