Should I Brush My Cartridge After Each Use?

After each record side, I brush with the supplied stylus brush that came with my Dynavector. Always from back to front about 2-3 times. Every 2 days or so, I do the simple Magic Erasure cleaning.
Oh, and I also clean each side of the record just prior to playing with a carbon fibre brush.

RE the appraisives vs. solvents question; don't forget that we are dealing with diamonds here!! I would be much more concerned with solvents attacking the adhesive and the suspension.

Hadn't thought of the adhesive gluing the stylus onto the cantelever. I had thought of migration of solvent up the cantelever to the suspension. Doesn't seem to be a problem for either though.

Ultrakaz,

Thanks for the tip on the KOS. I don't know if smaller pores would clean better, but they might reduce the risk of snagging the stylus.

Piedpiper,

We're on the same page re: the lazy, hazy, crazy Roy. Wire doesn't matter. VTA/SRA changes aren't audible. Scraping dirt against a plastic groovewall with a diamond chisel at hundreds of psi will magically clean the groove without damaging the plastic. As you said, whatever floats your boat.

Two seconds of ME (or KOS) after each side is enough to prevent all buildup, but it's nowhere near abrasive enough to damage a diamond - as Swampwalker pointed out. In fact, if a stylus is neglected and the buildup gets thick/stubborn enough, the ME won't even remove that.

Just last week I saved a ZYX UNIverse that hadn't been cleaned in a year. It sounded horrible and the owner was worried the cartridge was toast. The ME wasn't aggressive enough to remove all the baked on crud so I resorted to Linn's trick, a few delicate swipes with a sliver of 2,000 grit silicone carbide paper. Voila! Stylus looks like new, cartridge sounds like new.

As Jeff Jones said, you do what you have to do. For emergency rehabs a little tough love Linn style works wonders, and so does single malt!