platine motor with nylon thread

Mike,

I run my Platine with a linen thread. After some time the thread stretches and you need to move the motor unit away from the platter to keep the tension and speed up. With linen,it eventually snaps. With nylon, you can keep going for much longer - just make sure that the thread id taut.

Charlie

Thanks Bigbucks and Charlie,

That is exactly what I'm experiencing,I'll put on an LP and the speed has slowed quite noticably,I then realized the linen(sorry I'm using linen not nylon) was extremely loose.I moved the motor further away and speed is good again.I guess I'll just keep checking for this and when the linen breaks replace.
What a great table though,having tons of fun.Just for your info I have a basis vector 3 arm and ZYX Airy 3 s-sb cart.

Any concern for the thread snapping during playing session? i.e LP or cart damage

Thanks again,Mike

i have a micro seiki rx1500 and the motor is separate from the platter. i use dental floss as a drive belt. there are no worries of stretching with it. you may also experiment with using 1/4" reel-to-reel tape as a belt. i have not tried it yet, but it's on the list of to-do's...
don

Mike,

When the thread starts to stretch, you'll notice that the thread looks to have a varying diameter. If the thread snaps, it just falls down. I've had it happen to me a few times; certainly had no problems yet with it hitting the cart or arm.

Charlie

Thanks Don,maybe one day I'll try those as well.

Thanks again Charlie I'll keep my eye on that.

Mike.