Tonearms without anti-skate, damage to records?

I set AS at a minimum with the Pro-Ject 9C carbon fiber arm on 2Xperience table with Benz Ace. I agree with Mfsoa.....don't like the sight of that weight swinging but I do use AS. I would prefer an arm with other type of AS adjustment without the weight, although some say the weight is the better approach....go figure.

The RS-A1 and the new Nottingham tonearm on the 294 model do not have anti-skate, because the headshell (and therefore the cartridge) is not set at an angle to the arm tube. Thus skating force is not generated. I think there are other older tonearms that are so designed. Perhaps yours is one of those.

unless your arm is a tangential design, all pivoting arms generate 'skating force' regardless of the angle on the arm tube. it is the angle deviation of the stylus from perfect tangent that causes the force. that is why AS is so difficult to set and wrong for the most part, but some AS, I think, is better than none, just don't go overboard!

Bob P.

Bob P., The headshell on the RS-A1 tonearm has a unipivot bearing right at its base,in addition to the one at its main pivot point (so there are two articulations). Thus in theory the cartridge CAN always maintain tangency to the groove, and no skating force is generated. However, you are probably correct in general. (I've got to think about this a bit longer, and it does seem to me I've read in two other sources that skating force is generated by the offset headshell in 99.9% of all modern tonearms.)

>>09-28-07: Lewm
The RS-A1 and the new Nottingham tonearm on the 294 model do not have anti-skate, because the headshell (and therefore the cartridge) is not set at an angle to the arm tube. Thus skating force is not generated.<<

That is wrong.

All pivoting tonearms according to the basic laws of physics are affected by centripetal force.