2. analog
  3. 1192193123

Installation Instructions??

Regarding the installation of the cartridge in a tonearm. Is there a suggestion how to get the tonearm wires on to the pins of the cartrige? Last time I tried, my hand slipped because of a tight fit of the pins, and I broke off the conector on the Valhalla wire of the VPI arm. VPI sent me a new arm much to their credit, but I would not like to do that again. Do you install the wires, and then affix the cartridge into the headshell?? Do you use a special tool,etc. etc.
128x128stringreen
bdgregory
1,715 posts
 
I use needle-nose pliers, although it's still possible to slip and do damage f you're not extra careful - especially in the case of a tight fit. It's hopeless for me to try this using my fat fingers.
swampwalker's avatar
swampwalker
5,138 posts
 
Stringreen- Needle nose pliers are good, but also be careful not to use too much force. If the clips do not slide on with a minor amount of pressure, try opening them up a LITTLE bit by using a round toothpick inserted into the opening.
Ag insider logo xs@2x
rauliruegas
13,101 posts
 
Dear Stringree: You can use your hand or like Bdgregory suggest a needle-nose pliers. It is better to make the wires set-up before you mount the cartridge and before that check if the wire clips could connect easy to the cartridge pins and if are a little " narrow " then use a tootpick to make " bigger " and then to the cartridge pins.
Anyway you habe to do it with care.

Regards and enjoy the music.
Raul.
More to discover