I remember buying two belts (or was it three?) from different sources for an AR ETL ONE and not one of them worked properly. I wouldn't be surprised if there is quite a bit of hit or miss with aftermarket belts and can only suggest you try one out from a different source. If SOTA uses that length it may be a good idea to pay whaeever it is SOTA asks to get one. Good luck.
Suggestions for stretching turntable belts?
I have had a great deal of dificulty finding TRUE 35.1" turntable belts (as used by Sota,the Luxman PD 300,B+O 4002/4004,the Empire tables and some older Pioneers.I have gotten them from many sources- PRB,Ebay,etc. and they all seem to measure about 34".Needless to say with a floating subchassis table this will not work as it pulls the platter toward the motor spindle.In some cases it will even jump off!Is there a good technique to uniformly stretch these? I have even painstakingly cut the belt in half length wise with an exacto knife to try to reduce the tension.
- ...
- 6 posts total
| Post removed |
- 6 posts total