Graham Phantom damping fluid level.

I've been following this thread off and on since it started. In my previous configuration (using a Koetsu Jade) I got good results with the fluid level about 1mm past the start of the square shank (new bearing cap).

I just installed the Transfiguration Orpheus and found that I needed to remove some fluid... and am still fine-tuning. Looks like I'm going to land in nearly the same spot as Sirspeedy... just a smidge past the start of the square shank.

I actually took the level way down and the sound was very good, but on certain recordings the bass was getting muddy. I also noticed that the effect of the anti-skate appears to be increased with less fluid. Makes sense if you think about it.

With the low fluid level I was actually having problems with the armwand drifting to the outside of the LP as I was trying to lower it.

Sirspeedy: What kind of anti-skate setting are you using with the Orpheus? I'm finding that it doesn't need much... I currently have the weight set such that the first part of the thread is just barely showing.

Bofh,I'm still playing with antiskate.I have a few more sessions before I really know it,in my set-up.Right now,I have "two" notches showing,on the "bar".Will be making more adjustments,for sure.BTW,the fluid,on the bottom of the squared off point,is "set in stone" for me,with my own Orpheus.....Nice cartridge,heh?
Best

It's wonderful... I'm playing with VTA now... I'm finding that tail up is producing much better results for me than level or tail down. This is the exact opposite of any other cartridge I've ever owned.

Various searches that I've done are confirming this as well. Have you experienced the same with yours?

Bofh,with tail up too much I don't like the tonal quality I get.Down gives me a slightly deadened sound.I am "about" parallel to the LP(cartridge body),with an itty bitty tail up position.BTW,the azimuth is "incredibly" important with this cartridge.Absolutely SPOT on is mandatory!!Remember,my cartridge is not close to being broken in,so things will change....An amazing little device though!!
Best

Sirspeedy, speaking of azimuth....how do you verify "spot on" azimuth? BTW, I've been living with the fluid level just above the start of the squared off shank myself and it is much better.
Now if azimuth could be set accurately without the use of meters and test records, etc. I'd be ecstatic. What's your secret method? LOL..