Graham Phantom damping fluid level.


Bob Graham says to use enough fluid to bring the level up to the top of the square profile machined on the bearing cap. The square is only about 1/4" in length. My question is, What level works best for you in relationship to this "square" profile?

I have tried only 3 different levels of fluid in my setup (maximum level to top of square, almost no fluid at all, & to the bottom of the square) but can't seem to obtain optimum results so I'm wondering what others use, although I guess it's really cartridge dependent. Is the fluid level super sensitive? FWIW I'm using a Koetsu RSP.
frank_sm
Hevac,some test records(I own the Telarc Omni-disc)may not allow for the distortion to "totally" go away.I know my Phantom,using my Omni-disc still exhibits a certain degree of distortion in one channel.I believe we want to shoot for least amount heard,if it cannot be totally eliminated.
What I do,is get familiar with the actual "volume" of the distortion,as well as how long the distortion lasts,timewise.I play the track over,quite a bit,to become familiar.
I voice my arm for lowest volume,and shortest duration of this distortion,but one can always go from "that" point using one's ear,as well as watching the cantilever trace a groove,when viewed from straight ahead(front of cartridge/arm).It should be as vertical as possible,from a frontal view,as a disc spins.
Good luck.
thanks for the response Hevac. I appreciate you reaching out. I hope Bob Graham gets well soon.
I apply the fluid as recommended. If the sound is a bit dull, I use a syringe with an 18 gauge needle to remove a little bit; wait several hours, and repeat until it sounds right. It is not precise, but I wouldn't obsess on the fluid level. There has to be a point that we enjoy listening to the darn thing.

Congratulations to Sirspeedy on the aquisition of his new tonearm.