do tubes have anything to do with volume?

i've got the preamp at about all the way up. i can blast it, but i was just wondering if things would sound louder with new tubes. the tubes are about three or fours years old.

I guess it's possible the tubes are so bad it's effecting overall gain. Did you own the amp and preamp three years ago? I ask because you say the tubes are that old.

If you have other tubes it would be an easy test.

the first and easiest thing to check is tubes, but it's possible there's something else wrong. I had a similar problem with an amp that turned out to be a combination of bad power tubes, and a bad resistor.

To simply answer your question -- tubes have nothing to do with volume that I know of.

If you're talking about a lower/higher noise floor -- that is certainly possible.

The thing that baffles me in that you say, "I've got the preamp at about all the way turned up." Just about every active preamp I know of has enough gain to drive any amp into clipping. Why don't you back off the volume a bit on the preamp so the tubed amp doesn't clip when it runs out of steam on on peaks. That is definately not good.

50wpc is not a lot, but without knowing what preamp/amp/speakers you are using, its kind of hard to give good advice.

Of course if your preamp is of the passive level control variety, ignore this.

I think they affect volume. If your tubes are quite old and near the end of their lives, they may sound weaker and definitely less dynamic. Output tubes in my system that are testing at 50% will have muddy bass, soft highs and not a lot of headroom.