2. analog
  3. 1206752683

Help VPI SDS Issue

I took the plunge and got the SDS. Wow what a difference but I am having an issue. (I am using the 600 rpm motor) In order to get the motor to spin the platter I have to push it to start it moving. The motor is on but it sound like to is hesistating. I unplugged the SDS and no issue it starts right away. Is this an issue with the 600 vs 300 motor?
autodexr
rushton's avatar
rushton
2,445 posts
 
You can find out by simply bypassing the SDS and again plugging the motor directly into your AC outlet. See if you get a different result.
.
sidssp
1,077 posts
 
What output voltage did you set it to. If you set it too low, the motor may not have enough torque.
autodexr OP
49 posts
 
I have it set on for example 33 1/3 rpm I have it set a 72/60
autodexr OP
49 posts
 
I think this is definatly a torque issue as a little nudge gets the table going but its seems like I shouldnt have to do this
rothmanbrad
34 posts
 
The motor is fine, it needs a push just like when you start at 45rpm sometimes. but you ruined your belt by putting powder on it.
More to discover