What loading with Pass Xono / Helikon SL?

"but loading is such a personal thing, i don't think there is a correct formula for it and you have to talk to people who have exactly the same equipment and preference, otherwise it's all just talk"

EXACTLY! That is the EXACT reason I put that excerpt above. There is no value that can be determined until the above information is considered. The Pass provides tremendous loading variance. The optimum loading value will be dialed in after the cumulative total above impedance, capacitance and inductance levels create the loading requirements.

Dear Shsohis: The Pass Xono is a very decent phono stage and due to the low internal helikon resistance ( 5.5 Ohms ) IMHO it will be perform very good with a load impedance of 100 Ohms.

I owned the Helikon with good success at that impedance load.
In many ways as Jcarr point out the impedance load value is system dependent and you have to set up where you hear the best natural balance music sound reproduction on recordings that you know in deep, looking too for the best extreme frequency range best reproduction ( the load impedance changes affect mainly the high frequencies on your phono stage. ).

Btw, Buscis2 post speaks about " capacitance " and this " figure affect " the response on a MM cartridge but there is no change in a very low internal resistance cartridges like your MC Helikon ( at least not at pf values that are the standard ones in a phono stage like your Pass Xono. ) so don't worry about.

Regards and enjoy the music.
Raul.

I recently found that when I shunt the gain to -4dB of the original that I can increase the loading from 5.4ohm to 9.5ohm and it sounds more open, but if I load it higher it sounds too bright at the top. It just seems a delicate balance and your best bet is to play with the loading in incremental steps in either direction to see what you prefer.