Can anyone recommend a Phono Pre Amp?


Hello again,
I have a Project 9 with a Dynavector X-H high output cartridge connected to my Musical Fidelity XLPS-v3 by Synergistic Looking Glass active cables. I'm driving all this with Rogue Audio 150 monoblocks through a Rogue Audio 99 pre amp and Martin Logan SL3's. My system sounded bright at first but after about 150 hours of use warmed up quite a bit. The Musical Fidelity is kinda warm but dry. I have also tried the PS Audio phono pre amp that had way more detail but was a little edgy and lacked mid-range warmth. I'm looking to spend about $1ooo, hopefully less. Any recommendations?
128x128zeal
OK so far I have auditioned the PS Audio GCPH and the Musical Surrounding Nova Phonomena . And I most say the Nova sounded better to my ears. Less noise. Even My Musical Fidelity X-LPS v3 sounded warmer and less brittle then the PS Audio. But I'm still missing a tubes golden glow.
I think a tube amp that can handle my high output Dynavector MC cartridge might be my best bet. Any ideas? Any more suggestions?
Viper that Dodd is gorgeous! Is that a burl wood front?
Zeal what about the Dynavector P75 with the 20XL, must be good synergies there?
08-15-08: Mikeyc8
Viper that Dodd is gorgeous! Is that a burl wood front?
Zeal what about the Dynavector P75 with the 20XL, must be good synergies there?

Mikeyc8, it's quilted maple.
When I tested out Dynavector P75, I find that it does not have enough extension on both high and low frequency.
Viper when you tested the P75 was it with a Dynavector cart? I understand the the P75 has an "enhanced" mode that works particularly well with their LO Carts. This is a reason why I'm leaning heavily in favour of it for my 20XL cart.
If you can accept a used one you should look about a Klyne 6. Imho there are only two or three ones can top this phono stage and thay cost few times more money. Klyne is very flexible and will match perfect with yours DV.

Bye,
Marco